There is a hole on the trench and is coected to the corresponding lines on the rotating base by disposed outside the sleeve. The mandrel is mounted in the sleeve through a dual-bearing, and the sleeve is coected to the rotating base by bolts, and the O-ring seal is used at the coection.

The rotary joint is characterized in that the number of inputs is at least two, and at least two inputs are axially distributed along the axis of rotation, and each of the inputs is formed between the rotating shaft, and the transport hole and the output aperture. The quantity corresponds to the number of inputs, each conveying hole coects an aular chael and output aperture of an input.

The fiber rotary joints typically have a rotor, mounted for rotational motion around the axis relative to the stator. The fibers are in communication with the rotor OEM Brass Hose Coector manufacturer and the stator, respectively. The optical signal is suitable for transmitting the interface between the rotor and the stator is transmitted in any direction in both directions; means respectively, from the rotor to the stator, vice versa.

There is a large number of applications, requiring traffic on the transmission side of the rotating coector rotation interface, a data stream transported in a fiber, by spaing the collimated lens, the highest signal strength and the smallest change in the signal strength, The rotary joint rotor and all relative angular positions between the stator are transmitted.

The data stream thus transmitted can be introduced to another optical fiber on the receiving side of the interface in another collimation lens. In some applications, the fibers on the transmitting side of the fiber rotary joint interface are not mapped to a specific optical fiber on the receiving side. 

امتیاز بدهید :